Who do we protect?
All people who carry out daily activities and need specific heel protection.
Who do we protect?
All people who carry out daily activities and need specific heel protection.
What are the technical characteristics of the DAILY SPECIFIC TC4 OVER-SOLE heels?
When the foot hits the ground, there is often an impact between the heel and the ground called “heel strike” This impact consists of the transfer of body weight from the back to the front of the shoe during walking. During this stage, for a short period, the body is in free fall from a height of approximately 1 cm. DAILY SPECIFIC TC4 TALLONETTE OVER-SOLE heels protect against the impact generated by heel strike with surfaces.
They are reinforced with a 4mm thickness, light and space-saving for specific heel protection.
They are coated with long-lasting anti-abrasion fabric.
They are placed on top of the original insole (OVER-SOLE) and can be cut to size.
Not sure on how to choose your size?
Replace the DAILY SPECIFIC TC4 insoles after 2 years from first use or sooner if heavily used.
Wash it in warm water, use a mild soap and rub it with a non-abrasive sponge.
Take a pen and scissors and use one of the following methods to cut the insole to size:
– remove the original insole from the shoe, place it on the NOENE® insole (A), draw the outline (B) and cut it (C)
– if the original insole is not removable from the shoe
• use the cutting lines if present under the NOENE® insole corresponding to your size and cut it (C)
• cut the CUT MODEL matching your size, place it on the NOENE® insole (A), mark the outline (B) and cut (C)
Take a pen and scissors and use one of the following methods to cut the insole to size:
– remove the original insole from the shoe, place it on the NOENE® insole (A), draw the outline (B) and cut it (C)
– if the original insole is not removable from the shoe
• use the cutting lines if present under the NOENE® insole corresponding to your size and cut it (C)
• cut the CUT MODEL matching your size, place it on the NOENE® insole (A), mark the outline (B) and cut (C)